Code-3 21TR & 21TR Plus Manual do Utilizador descarregar pdf (Página 15)

Take Down and Alley Light Flash Mode - 21TR Plus

The Take Down and Alley Lights can be programmed to ash at different rates. Reference Table 6.

Step 1

Power-up the light bar. Select the Take Down Flash Mode (BLK) or the Alley Flash Mode (BLU/WHT) by applying +12V to the appro-

priate wire. Programming will not work if more than one function is selected at a time.

Step 2

Observe the ash pattern and determine which pattern is in operation (see Take Down and Alley Flash Patterns). This table shows

the available ash patterns. Once the ash pattern has been determined, proceed to Step 3.

NOTE: The default ash pattern for Take Down and Alley Lights is Medium Single 115FPM.

Step 3

Scroll to the next pattern by momentarily holding the BLK/RED wire to +power for ~one (1) second. The light bar will stop ashing

when the wire is connected to +power. Release the wire and the next pattern as listed in Table 6 will begin to ash. The new pattern

is automatically stored each time.

NOTE: To restore the Factory Default Take Down and Alley Flash Patterns, hold the BLK/RED wire to +12V for ~four (4)

seconds.

Table 6 - Flash Patterns - Alley and Takedown Lights - 21TR Plus

PATTERN NUMBER PATTERN DESCRIPTION

1 FAST QUAD 80FPM

2 SLOW QUAD 60FPM

3 FAST SINGLE 375FPM

4 MEDIUM SINGLE 115FPM *

5 SLOW SINGLE 60FPM *

6 FAST DOUBLE 115FPM

7 SLOW DOUBLE 60FPM *

8 FAST SIX 80FPM

9 SLOW SIX 60FPM

10 VARIABLE RATE SINGLE

11 NFPA QUAD 75FPM

12 CYCLE FLASH

1 2 ... 10 11 12 13 14 15 16 17 18

Sem comentários

Code-3 21TR & 21TR Plus Manual do Utilizador Página 15