Code-3 MX 7000 Manual do Utilizador descarregar pdf (Página 27)

PROBLEM POSSIBLE CAUSE SOLUTION

Lighthead oscillates when selecting Lighthead not sensing position.

Alley and/or Takedown modes. Check the following:

Bad wiring harness Replace wiring harness

Bad connection Check connections (Figure 10 & 11)

Failed position sensor Replace lighthead assembly

Lighthead doesn’t move when Alley Failed lighthead assembly Replace lighthead assembly

and/or Takedown mode is selected,

but moves in Intersection mode

Lighthead does not move when any Bad motor wire to module Check connections / Replace wire

mode is selected. Failed light bar wire harness Check light bar wiring harness

No power to control module Check +12VDC switching control

Failed lighthead assembly Replace lighthead assembly

Failed control module Replace control module

Lighthead operates properly, Lamp burnt out Replace lamp (50W maximum)

but lamp is not on Bad lamp wire to module Check connections / Replace wire

Driver side lighthead oscillates and Driver side lighthead not sensing

Passenger side lighthead does not Check for the following:

move when Takedown is selected. Bad wiring harness Replace wiring harness

Note: In Takedown mode,Passenger Bad wiring harness connection Check connections (Figure 10 & 11)

side lighthead will not move until Failed position sensor Replace lighthead assembly

Driver side lighthead has located

Intersection mode selected, Driver No problem Normal operation, Intersection mode

and Passenger side Alley modes overrides Alley mode.

do not function

Takedown mode selected, no No problem Normal operation, Takedown mode

other modes operational overrides all other modes

Troubleshooting

All Excalibur strobe lightbars are thoroughly tested prior to shipment. However, should you encounter a

problem during installation or during the life of the product, follow the guide below for information on repair and

troubleshooting. Additional information may be obtained from the factory technical help line at 314-426-2700

ext. 2131.

NO STROBE LIGHTS IN THE LIGHTBAR OPERATE - Check the following: 1) +12 VDC source connection

for the control switch box and any in line fuse 2) Connection of the RED and RED/BLK wire at the control

switch box 3) Check the 15 Amp ATO fuse on each power supply. If the fuse is blown, replace it with another

15 Amp fuse and test the lightbar. If the fuse continues to blow, return the power supply only, NOT the entire

lightbar, to the factory for service. For instructions on power supply removal see the " Electronics Module

Removal " section of this manual.

Do not replace the fuse with one of a higher rating. This will damage the power supply and void all

warranties.

WARNING!

ONE STROBE LIGHT MODULE DOES NOT OPERATE - Check the defective strobe light module by

switching it with a module that is known to be working.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32

Comentários a estes Manuais

Sem comentários

Code-3 MX 7000 Manual do Utilizador Página 27

Comentários a estes Manuais

Manuais e produtos relacionados com Iluminação Code-3 MX 7000