Code-3 NightProbe in Lightbar Manual do Utilizador descarregar pdf

NIGHTPROBE

IN LIGHTBAR

INSTALLATION

& OWNERS

MANUAL

REMOTE

CONTROLLED

SPOTLIGHT

Introduction

The NightProbe , NP 130, product can be mounted in the center section of a Code 360, Excalibur or MX

lightbar. This offers the user an unobstructed 360 degrees of light around the vehicle.

Installation & Mounting

1. Install the circular gasket on the upper surface of the lens cover and spacer.

2. Route the cables from the bottom of the spotlight through the gasket, lens cover as shown in

Figure 2.

3. Place the other two spacers on the lens cover. They will be sandwiched between the lens cover and the

mounting plate.

4. Place the mounting plate over the spacers, align the holes in the mounting plate with the holes in the lens

cover.

5. Attach the spotlight with four #6x3/4” screws to the mounting plate.

6. Remove the center lens of the lightbar and keep the four lens clips for reuse.

7. Route the cables through the existing hole in the bottom of the lightbar, insure that there is adequate

length to reach the area in which the controller is to be mounted.

8. Install the spotlight mounting bracket to the lightbar frame using eight #8 x .270” screws. The bracket

should fit snugly between the plastic ribs of the lower lens to ensure alignment with the lens/mtg plate

assy.

9. Install the spotlight and lens/mtg plate to the lower lens being careful not to pinch the cables. Fasten with

four #14 x 3/4” washer seal screws.

10. Reinstall the four lens clips.

11. Connect the wiring and the control box per instructions with the spotlight.

1 2 3 4

Resumo do Conteúdo

Página 1 - & OWNERS

NIGHTPROBE®IN LIGHTBARINSTALLATION& OWNERSMANUALREMOTECONTROLLEDSPOTLIGHTIntroductionThe NightProbe , NP 130, product can be mounted in the cente

Página 2 - Parts List

Parts ListRef No. Description Part No. Qty.1 Spotlight -Complete S50597 012 Gasket, .062 thk foam, RE41E black T05084 013 Cover S96255 014 Fastener #1

Página 3 - WARNING!

The use of this or any warning device does not ensure that all drivers can or will observe orreact to an emergency warning signal. Never take the rig

Página 4 - PRODUCT RETURNS

NightProbe and Code 3 are registered trademarks of Code 3, Inc. a subsidiary of Public Safety Equipment, Inc.Revision 2, 03/2006 - Instruction Book Pa

Comentários a estes Manuais

Sem comentários

Code-3 NightProbe in Lightbar Manual do Utilizador

Consulte online ou descarregue Manual do Utilizador para Iluminação Code-3 NightProbe in Lightbar. Code 3 NightProbe in Lightbar User Manual Manual do Utilizador

Resumo do Conteúdo

Comentários a estes Manuais

Manuais e produtos relacionados com Iluminação Code-3 NightProbe in Lightbar