Code-3 LIT3 Mounting Kit Manual do Utilizador descarregar pdf (Página 5)

Installation Instructions-Cont.

Note: If you are installing a Standard Version of the Mounting Kit, skip Steps 13 through 16 and proceed with Step 17

Standard Version" at the bottom of page 6 of this manual.

Step 13 Feed the ends of the power wires from the Lightbar through the holes in the Mounting Feet and into the Mounting Foot Wire Pockets (see

Figure 15) (See addendum for installation of the through-the-frame wires if your Lightbar is not equipped)

Step 14 Plug the ends of the power wires from the Lightbar into the power wires from the Mounting Feet (see Figure 16)

Step 15 Tuck the excess lengths of the power wires into the Mounting Foot Wire Pockets (see Figure 17)

Step 16 Position the wire covers into the Mounting Foot Wire Pockets (see Figure 18), insert a #8 X 1/4" Sheet Metal Screw into it's mounting hole

(see Figure 19), and tighten the Sheet Metal Screw with a 1/4" hex Driver or a #20 Torx bit (see Figure 20)

FIGURE 15 FIGURE 16 FIGURE 17

FIGURE 19 FIGURE 20FIGURE 18

Step 17 Lighted Version Slip the Ring Terminal Ends of the Black Ground Wire under the rib on the Mounting Feet (see Figure 21), over

the ends of the

5/16"-18 Carriage bolts (see Figure 22) and position a 5/16" split washer and thread a 5/16"-18 Hex Nut onto each of the

Carriage Bolts (see Figure 23). At this point the assembly should look as shown in Figure 24.

FIGURE 21 FIGURE 22 FIGURE 23

FIGURE 24

1 2 3 4 5 6 7 8 9 10 ... 15 16

Sem comentários

Code-3 LIT3 Mounting Kit Manual do Utilizador Página 5