Code-3 PSE235 Remote Strobe Power Supply Manual do Utilizador Página 1

INSTALLATION& OPERATIONMANUALPSE235TMREMOTE STROBEPOWER SUPPLYIMPORTANT:REMOTE STROBEPOWER SUPPLYContents:Introduction ...

Code 3, Inc.10986 N. Warson RoadSt. Louis, Missouri 63114-2029—USAwww.code3pse.comWARRANTYThis product was tested and found to be operational at the t

IntroductionThe PSE235 Series Remote Strobe Power Supply represents the latest in state-of-the-art strobe warningtechnology. The latest in MOSFET tech

The use of this or any warning device does not insure that all drivers can or will observe orreact to an emergency warning signal. Never take the rig

Installation and MountingMOUNTING THE MODEL PSE235 REMOTE STROBE POWER SUPPLYTo obtain maximum performance and durability the Model PSE235 should be m

52. After the cables have been properly routed for each strobe head they will have to be terminated with thethree pin AMP socket housings provided. T

3. With the AMP 3 pin connectors terminated properly , plug each cable into the appropriate 3 position socketon the PSE235 strobe power supply, see F

Switching Control Variations and ConnectionsThe following diagrams show some of the wiring configurations possible for the various flash modes availab

MaintenanceThe PSE235 Remote Strobe Power Supply has been designed to provide trouble free service. In case ofdifficulty, refer to the troubleshootin

9INTERNAL FUSE REPLACEMENTIn the event that is determined the internal fuse needs to be replaced, the following procedure should be used(See Figure 5)