Code-3 Triumph Manual do Utilizador Página 5

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 4
STEP 3:
Continue applying power to the BLK/RED wire and the wire(s) from Step 1. Refer to Table 4A, 4B, or 4C for the available ash patterns.
To increment to the next pattern, momentarily hold the appropriate pattern selection wire (see Table 2) to +power for less than two seconds and
then release. The four corner light heads will turn on steady to indicate that the pattern has been incremented.
To decrement to the previous pattern, momentarily hold the appropriate pattern selection wire (see Table 2) to +power for two to four seconds and
then release. The four corner light heads will turn on steady and then turn off to indicate that the pattern has been decremented.
After the pattern selection wire has been released, the new pattern will begin to ash and is automatically stored each time. Repeat this step for
each pair of heads using the appropriate pattern selection wire (see Table 2).
NOTE: To restore the Factory Default Emergency Warning Flash Patterns, hold any of the pattern selection
wires to +power for more than four seconds. The four corner light heads will turn on steady, turn off and
then turn on steady again to indicate that the Factory Default Emergency Warning Flash Patterns have been
restored. The factory defaults for a progressive switch application (Level-1, Level-2 and Level-3) are identied
in Table 3.
STEP 4:
Repeat steps 1 through 3 for each of the seven possible 3-Level modes as desired.
TABLE 1A: 3-LEVEL MODES OF OPERATION
MODE NUMBER WIRES ACTIVATED
L1 GRN/BLK (LEVEL-1)
L2 WHT/BLK
L1 + L2 GRN/BLK & WHT/BLK (LEVEL-2)
L3 RED/BLK
L1 + L3 GRN/BLK & RED/BLK
L2 + L3 WHT/BLK & RED/BLK
L1 + L2 + L3 GRN/BLK, WHT/BLK, & RED/BLK (LEVEL-3)
TABLE 2: PATTERN SELECTION WIRES
WIRE COLOR PAIR OF HEADS CONTROLLED
GRN/WHT FRONT OUTBOARD
BLU/BLK FRONT INBOARD
ORG/BLK FRONT CENTER
GRN FRONT CORNER
BLK/WHT REAR OUTBOARD
RED/WHT REAR INBOARD
BLU/WHT REAR CENTER
BLU REAR CORNER
BLK ARROWSTIK® END FLASH
TABLE 3: FACTORY DEFAULT EMERGENCY WARNING FLASH PATTERNS (PROGRESSIVE SWITCH)
LAMP POSITION LEVEL-1 DEFAULT LEVEL-2 DEFAULT LEVEL-3 DEFAULT
FRONT OUTBOARD NULL FLASH (13) FAST QUAD (1) CYCLE FLASH (12)
FRONT INBOARD NULL FLASH (13) FAST QUAD (1) CYCLE FLASH (12)
FRONT CENTER NULL FLASH (13) FAST QUAD (1) CYCLE FLASH (12)
FRONT CORNER NULL FLASH (13) FAST QUAD (1) CYCLE FLASH (12)
REAR OUTBOARD FAST QUAD (1) FAST QUAD (1) CYCLE FLASH (12)
REAR INBOARD FAST QUAD (1) FAST QUAD (1) CYCLE FLASH (12)
REAR CENTER FAST QUAD (1) FAST QUAD (1) CYCLE FLASH (12)
REAR CORNER FAST QUAD (1) FAST QUAD (1) CYCLE FLASH (12)
ARROWSTIK® END FLASH FAST QUAD (1) FAST QUAD (1) CYCLE FLASH (12)
Vista de página 4
1 2 3 4 5 6 7 8 9 10 ... 15 16

Comentários a estes Manuais

Sem comentários